1 QR523-1702320 BALL ASSY,RESTRICT 2 QR523-1702102 ROD SHIFT 1ST and 2ND 3 QR523-1702202 ROD SHIFT 3RD and 4TH 4 QR523-1702304 ROD SHIFT 5TH and R. 5 QR523-1702103 SUPPORT CROSSSHAFT 1ST and 2ND) 6 QR523-1702101 FORK SHIFT 1ST and 2ND 7 QR523-1702201 FORK SHIFT 3RD and 4TH 8 QR523-1702203 SUPPORT CROSSSHAFT 3RD and 4TH) 9 QR523-1702301 FORK SHIFT 5TH and R. 10 QR523-1702302 SUPPORT CROSSSHAFT(5TH and R.) 11 QR523-1702303 BLOCK,DRIVING 12 Q5280524 PIN,ELASTICITY Reasons for transmission shift difficulty: 1. When the shift lever is heavily operated or deviates from the gear position to engage the gear, it is caused by the failure of the control mechanism. In case of mechanism maladjustment, the length and position of the pull rod shall be adjusted according to the regulations; If the parts are worn or deformed, replace the worn parts. 2. When the gear feels correct and feels difficult or makes a slight noise when engaging second, third, fourth and fifth gears, the synchronizer is damaged, mostly due to the reduced wear effect. 3. During operation, it is found that there is abnormal noise in the transmission during neutral sliding, and there is the same sound at the moment of shifting. It is difficult to shift, mostly due to the looseness of the synchronizer. 4. It is difficult to shift gears 4 and 5. If you have the feeling of shifting gears twice, it is due to excessive wear of the shift fork and shift fork groove or deformation and failure of the synchronizer cone ring. Troubleshooting for difficult transmission shifting: 1. Replace the deformed fork. 2. Check whether the synchronizer positioning spring and the external teeth of the spline hub are stuck and deformed. If so, replace them. 3. Replace the connecke of the clutch pedal and the clutch itself. In addition to the normting parts. 4. Check the free stroal wear and tear of automobile shift fork, it is also caused by improper use. 1. If the clutch is not fully engaged, the gear shift is not in place. It is caused by the driving habits of two people. Some people are used to putting their hands on the gear lever when driving.、 In addition to the normal wear and tear of automobile shift fork, it is also caused by improper use. 1. If the clutch is not fully engaged, the gear shift is not in place. It is caused by the driving habits of two people. Some people are used to putting their hands on the gear lever when driving.